Showing 3730–3740 of 8865 results

SRT3000RMXLA-NCFeaturesAPC Smart-UPS SRT 3000VA RM 120V Network CardHigh density, double-conversion on-line power protection with scalable runtimeIncludes : CD with software , Documentation CD , Installation guide , Network Management Card , Rack Mounting brackets , Rack Mounting support rails , USB cable , Warranty card- 10/100 BaseT ConnectionConnect the device to a network using a 10 or 100 BaseT connection- Battery failure notificationProvides early-warning fault analysis on batteries enabling timely preventive maintenance- ECO ModeOperating mode that by-passes unused electrical components in good power conditions to achieve high operating efficiency without sacrificing protection- Green modePatent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.- LCD graphics displayText and mimic diagrams that display modes of operation, system parameters and alarms.- Rack/Tower convertibleProtects the initial investment in the UPS when migrating from tower to rack-mount environment.Serviceability- Audible alarmsProvides notification of changing utility power and UPS power conditions- Disconnected battery notificationWarns when a battery is not available to provide backup power.- Predicitive failure notificationProvides early-warning fault analysis ensuring proactive component replacement.- Automatic self-testPeriodic battery self-test ensures early detection of a battery that needs to be replaced.- User-replaceable batteriesIncreases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)Protection- Generator compatibleEnsures clean, uninterrupted power to protected equipment when generator power is used.- Cold-start capableProvides temporary battery power when the utility power is out.- Power conditioningProtects connected loads from surges, spikes, lightning, and other power disturbances.- Input power factor correctionMinimizes installation costs by enabling the use of smaller generators and cabling.- Frequency and voltage regulationGives higher application availability by correcting poor frequency and voltage conditions without using the battery.- Resettable circuit breakerEasy recovery from overloads; no need to replace a fuse.- Safety-agency approvedEnsures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.Manageability- Network manageableProvides remote power management of the UPS over the network.- Serial connectivityProvides management of the UPS via a serial port.- SmartSlotCustomize UPS capabilities with management cards.- LED status indicatorsQuickly understand unit and power status with visual indicators.- InfraStruXure Manager CompatibleEnables centralized management via the APC InfraStruXure Manager.Adaptability- Plug-and-Play external batteriesEnsures clean, uninterrupted power to the loads when adding extra runtime to the UPS.- Flash upgradeable firmwareInstall maintenance releases of firmware remotely using FTP.- Rack/Tower convertibleProtects the initial investment in the UPS when migrating from tower to rack-mount environment.Availability- Temperature-compensated battery chargingProlongs battery life by regulating the charge voltage according to battery temperature.- Automatic internal bypassSupplies utility power to the connected loads in the event of a UPS power overload or fault.- Intelligent battery managementMaximizes battery performance, life, and reliability through intelligent, precision charging.- Scalable runtimeAllows additional run time to be quickly added as needed.- Automatic restart of loads after UPS shutdownAutomatically starts up the connected equipment upon the return of utility power.- Hot-swappable batteriesEnsures clean, uninterrupted power to protected equipment while batteries are being replacedMarketing Features- Avoids costly power problems by keeping your IT equipment and data protected and available.Network grade power conditioning protects from damaging surges and disruptive noise. The double conversion architecture provides tight voltage regulation, frequency regulation ,and zero transfer time to battery during power events.- Low operating and maintenance costs with proven reliability and intelligent battery management.Intelligent battery management, pioneered by APC, maximizes battery performance and life through intelligent, precision temperature compensated charging. Automatic self tests insure battery reliability and warn customers in advance of battery replacement. Convenient, easy to connect, hot-swappable battery modules provide battery replacement without powering down.- Save time with easy and convenient remote accessibility.Network manageable via serial, USB or optional Ethernet. Includes Powerchute® Network Shutdown Software for convenient monitoring and control, safe operating system shutdown, and innovative energy management capabilities.- Peace of mind that comes with full equipment compatibility and reliability of a leaderProvides pure sine wave output which is recommended by server manufacturers using active power factor corrected (PFC) power supplies. Safety agency tested and approved means that you can deploy Smart-UPS with confidence that they meet or exceed the industry’s most rigorous standards.

Tripp Lite SmartPro Line Interactive UPS with enhanced LCD interface offers network-grade power protection for critical server, network and telecommunications equipment. Line Interactive Uninterruptible Power Supply (UPS) with built-in Auto-Voltage Regulation (AVR) actively corrects brownouts and overvoltages back to usable levels while maintaining a full battery charge in case of power failure. Tripp Lite's unique configuration excels in exceptionally poor-power environments with two separate levels of voltage boost to correct both slight undervoltages and severe brownout conditions. Interactive LCD interface reports UPS operating mode, detailed UPS and site-power data, plus enables a variety of UPS setup and configuration options. Super-fast switchover from line to battery power occurs within milliseconds to maintain operation of connected equipment without interruption or reboot. 96% line-mode efficiency offers reduced heat emissions and operating costs. Network management interfaces support communications via USB, RS-232 and optional SNMPWEBCARD network interface. HID-compliant USB port enables integration with built-in power management and auto shutdown features of Windows and Mac OS X. Network communications ports enable detailed monitoring of equipment load levels, self-test data and utility power conditions. Includes PowerAlert monitoring software and complete cabling. Switched output load banks enable scheduled and real-time remote reboot and load shedding of select outlets. Emergency Power Off (EPO) interface. LCD display panel easily rotates for viewing in rackmount or tower configurations. Audible alarm with push-button momentary alarm-cancel and silent-mode configuration options. Programmable self-test. Field-replaceable, hot-swappable battery modules.- Tripp Lite SMART3000RMXL2U line interactive 2U rack/tower UPS with 3000VA / 3kVA capacity and extended runtime options- Line interactive UPS with Automatic Voltage Regulation (AVR) corrects brownouts and overvoltages from 83 to 145V- NEMA L5-30P input plug; 8 NEMA 5-15/20R and 1 L5-30R output receptacles, Two independently switchable output load banks- Maintains uninterrupted operation of connected networking equipment during blackouts, surges, brownouts and overvoltages- High 96% efficiency rating in line-power mode offers reduced power consumption and BTU emisssions- Internal batteries offer 10 minutes at 50% load (1440W) and 3 minutes at 100% load (2880W)- Extended runtime is available with optional BP48V24-2U (limit 1), BP48V60RT-3U (multi-pack compatible) and BP48V27-2US (multi-pack compatible) external battery packs- External battery configurations require the use of Tripp Lite's External Battery Configuration Software (see manual)- Hot-swappable, user-replaceable internal batteries and external battery packs can be replaced with no disruption to connected equipment- Front panel LCD monitoring screen with MODE and ENTER buttons reports operating mode with 5-bar battery charge graphic, plus 7 selectable screens of detailed UPS and site power information- LCD interface also supports a number of advanced user setup and operating preferences- Ships with 4 post rackmount installation hardware; Optional 2POSTRMKITWM enables 2 post rackmount/wallmount installation; Optional 2-9USTAND enables tower placement- Built-in USB, RS-232 and optional SNMPWEBCARD accessory monitoring options- HID-compliant USB port enables integration with built-in power management and auto shutdown features of Windows and Mac OS X- Included PowerAlert UPS monitoring software; Built-in Emergency Power Off (EPO) interface with cable

Tripp Lite Metered Power Distribution Units / PDU systems continuously report output load level in amps to help network managers prevent overloads and plan for future growth. Supplies equipment with continuous power from any protected UPS, generator or mains input power source. Highly reliable design includes rugged all-metal housing and secure rackmount installation with included mounting accessories.- 30A single phase 120V Metered Power Distribution Unit / PDU (Agency derated to 24A continuous)- Two-digit lighted meter reports total PDU input current in amps- Attached L5-30P 30A 120V input plug with 15 ft. / 4.5m line cord- 1U horizontal rackmount format installs in one rack space- 12 NEMA 5-15/20R outlets- Outlets are arranged in two loading banks, each with separate 20A breaker protection- Mounting flanges support installation in 2 and 4 post racks, with additional support for wall-mount and under-counter installation formats- Mounting ears are reversible for front or rear facing rackmount installation- Back panel grounding lug- TAA Compliant Version Available - Order Tripp Lite PDUMH30TAA

Cisco FIREPOWER 9300 CHASSIS FOR AC POWER SUPP